Fuji Xerox ApeosPort-V C2276, Administrator'S Manual

Page: 219 / 783

Connectivity & Network Setup
219
To
ols
5
ThinPrint

Port Status
You can use the machine for print in the ThinPrint .print environment. The machine
decompresses and prints the compressed print data sent from the print server.
Select [Enabled] when you use ThinPrint
®
.

Port Number
Enter a port number for ThinPrint from 1 to 65535.
The default value is 4000.
Important • Do not use any number s assigned to the other ports.
Note • ThinPrint is available when the communication protocol uses IPv4.
• The maximum of three connections are possible at a time.
Protocol Settings
Set the parameters required for communications. In [Protocol Settings], you can set the
following items.
Also on [Ping Connection Test], you can check whether or not the machine can be properly
connected to a network with the configured condition.
Ethernet Settings
Configure the Ethernet settings.

Ethernet1 - Network Name, Ethernet 2 - Network Name
When two Ethernet interfaces are used, specify the names respectively.
Note • This item is displayed only when Secondary Ethernet (optional) is installed on the machine.

Ethernet - Rated Speed / Ethernet 1 - Rated Speed, Ethernet 2 - Rated Speed
Set the communication speed for the Ethernet interface.
Note • The title of this setting item differs depending on the Ethernet interface configuration: When single
Ethernet interface is used, [Ethernet - Rated Speed] is displayed. When two Ethernet interfaces are
used, [Ethernet 1 - Rated Speed] and [Ethernet 2 - Rated Speed] are displayed.
 Auto
Select this to detect the Ethernet transmission rate automatically.

100 Mbps Full-Duplex
Select this to set 100BASE-TX (Full Duplex) as the default value.
 100 Mbps Half-Duplex
Select this to set 100BASE-TX (Half Duplex) as the default value.
 10 Mbps Full-Duplex
Select this to set 10BASE-T (Full Duplex) as the default value.
 10 Mbps Half-Duplex
Select this to set 10BASE-T (Half Duplex) as the default value.
 1000 Mbps
Select this to set 1000BASE-T as the default value.
Note • 1000BASE-T is not available for some models. An optional component is required.