Fuji Xerox ApeosPort-V 6080, Administrator'S Manual

Page: 327 / 745

Configuration of Store to Folder
327
Sc
a
nne
r En
v
iron
men
t Set
tin
gs
9
3
Set an IP address and the other addresses.
Skip this step if an IP address is already set.
If DHCP or BOOTP is available in your environment, configure the method for obtaining the
address. If an IP address cannot be obtained automatically or manual configuration is
preferred, confirm the settings of an IP address, a subnet mask, and a gateway address.
For information on how to set an IP address, refer to "Protocol Settings" (P.182).
4
Select [Close] repeatedly until the [Tools] screen is displayed.
5
Select [Close].
Note • Rebooting the machine may be required depending on the settings. When a message displayed on
the screen, follow the message and reboot the machine.
6
Print a configuration report to confirm that the WebDAV port is enabled and that TCP/IP is
set up correctly.
For information on how to print a configuration report, refer to "Print Reports" (P.92).
Step 2 Registering a Folder
Register a folder to store scanned data.
For information on registering a folder, refer to "Create Folder" (P.253).
Step 3 Configuring on the Computer
To use Network Scanner Utility 3, install Network Scanner Utility 3 on a computer.
Network Scanner Utility 3 is included in the Media (Software/Product Manual). For information on how to install the
Network Scanner Utility 3, refer to the Media (Software/Product Manual).
For information on the usage of the Network Scanner Utility 3, refer to "12 Computer Operations" in the User Guide.