Fuji Xerox ApeosPort-V 4020, Administrator'S Manual

Page: 168 / 611

5 Tools
168
Tools
5
Note • For [IKE Authentication Method], [Preshared Key], [DH Group], and [PFS Settings], consult your
network administrator.
z IKE Authentication Method
Set the IKE authentication method. Select from [Authenticate by Preshared Key] or
[Authenticate by Digital Signature].
z Preshared Key
Enter a preshared key. This setting is valid when [IKE Authentication Method] is set to
[Authenticate by Preshared Key].
z
Device Certificate
Select a certificate for IPSec communications.
Select a certificate when [IKE Authentication Method] is set to [Authenticate by Digital
Signature]. A self-signed certificate created by CentreWare Internet Services cannot be
used.
For more information on a certificate, refer to "Types of Certificate" (P.320).
z IPSec Communication
Select whether or not to enable IPSec communications.
z IKE SA Life Time
Specify IKE SA lifetime from 5 to 28800 minutes in 1 minute increments.
Note • The value must be greater than the value set in [IPSec SA Life Time].
z IPSec SA Life Time
Specify IPSec SA lifetime from 300 to 172800 seconds in 1 second increments.
Note • The value must be smaller than the value set in [IKE SA Life Time].
z DH Group
Set DH group. Select from [G1] or [G2].
z PFS Settings
Select whether or not to enable PFS.
z Destination IPv4 Address
Set the IPv4 address of the destination.
When entering an IP address, enter the address in the format "xxx.xxx.xxx.xxx", where
"xxx" is a numeric value from 0 to 255.
z Destination IPv6 Address
Set the IPv6 address of the destination.
When entering an IP address, enter the address in the format
"xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a hexadecimal value.
z Communicate with Non-IPSec Devices
Select whether or not to communicate with non-IPSec devices.
IEEE 802.1X Settings
„
IEEE 802.1X Settings
Configure the IEEE 802.1X settings.
z IEEE 802.1X
Set whether or not to use IEEE 802.1X authentication.
z Authentication Method