Fuji Xerox ApeosPort-IV C4430, User Manual

Page: 127 / 393

Output Format
127
Co
py
3
Handouts or Transparency Set & Handouts of Transparency Options, Booklet
Creation, Stapling, Build Job, Sample Set, and Combine Original Sets.
„ Collated
The machine outputs sheets sorted into sets that are arranged in page order.
„ Uncollated
The machine outputs the specified number of copies and sorts sheets by page.
„ Uncollated with Separators
The machine outputs copies with inserting blank sheets as a separator and sorts
sheets by page.
„ Separator Tray
When you select [Uncollated with Separators], select the paper tray to be used for the
separators.
Note • When you use the bypass tray, select [Tray 5] on the [Separator Tray] screen.
„ Staple
Specify the position for stapling. The number of sheets that can be stapled is 2 - 50
(when 80 gsm paper is used). Available paper types are: Plain paper, Recycled paper,
Reload paper, Bond paper, Heavyweight paper (106 - 163 gsm), Extra Heavyweight
paper (164 - 216 gsm), and Custom paper 1 to 5. If paper heavier than 90 gsm or lighter
than 60 gsm is used, outputs may not be stapled correctly even if the number of sheets
is 50 or less.
„ Original Orientation
Allows you to specify the orientation of the document so that the machine can identify
the top of the document.
Note • If the [Original Orientation] setting differs from the actual document orientation, the machine
may not detect the top of the document correctly.
z
Upright Images
Select this option when placing the top edge of the document against the top side of
the document glass or document feeder.
z
Sideways Images
Select this option when placing the top edge of the document against the left side of
the document glass or document feeder.
„
Offset Stacking
Allows you to select the output destination tray and offset operation.
The offset is a function for slightly offsetting and outputting each paper stack to allow
you to distinguish the separations. You can select from [Offset per Set], [Offset per
Job], [Offset Every N Pages], [Offset Every N Sets], and [System Default].
Note • This feature does not appear for some models. An optional component is required. For more
information, contact our Customer Support Center.
• If you select [System Default], the setting in the System Administration mode will be
effective. For information on how to change the setting, refer to "5 Tools" > "Copy Service
Settings" > "Copy Defaults" > "Output Destination" in the Administrator Guide.