Fuji Xerox apeosport-iv C3370, Administrator'S Manual

Page: 252 / 889

Tools
252
T
ools
5
do not set remote authentication, the machine uses the user ID and passcode of the
machine for authentication.
„
SMTP AUTH Login Name
Enter the user name for verification purposes at the SMTP server with up to 64 characters.
„
SMTP AUTH Password
Enter the password for verification purposes at the SMTP server. Up to 64 single-byte
characters are allowed.
Note
z
If you do not set the password, leave the text boxes blank and select [Save].
Remote Authentication/Directory Service
You can make the settings for the remote authentication server and directory service.
Note
z
DocuCentre series models can only support the services associated with searches for Address Book of "LDAP
Server/Directory Service Settings" (P.253).
Authentication System Setup
„
Authentication System
Allows you to select the authentication system from [Kerberos (Windows 2000)], [Kerberos
(Solaris)], [LDAP], [SMB], and [Authentication Agent].
After you change the authentication system, folders and job flow sheets used with the
previous authentication system are not deleted automatically. If these folders or job flow
sheets are no longer needed, delete them from the machine. If the same user IDs are also
used on the new authentication system, folders and job flow sheets can be used by the
same users.
Note
z This feature is available on the ApeosPort series models only.
„
Server Response Time-Out
Set the server time-out response between 1 and 75 seconds in 1 second increments.
„
Search Time-Out
Set the user information search time-out between 1 and 120 seconds in 1 second
increments.
Kerberos Server Settings
Configure the Kerberos Servers 1 to 5.
The settings in [Kerberos Server 1 (Default)] will be the default settings for authentication.
Note
z This feature is available on the ApeosPort series models only.
„
Primary Server Name/Address
Enter the primary server name or IP address.
Note
z For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to 255.
z For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.