Fuji Xerox apeosport-IV 6080, Administrator'S Manual

Page: 174 / 705

5 Tools
174
T
ools
5
„ ID
Specify a number to identify the recipients' telephone numbers.
If you specify "03", this VoIP gateway is used for the telephone numbers beginning with "03"
such as "0312345678" and "0312345679".
Note • If you specify a specific telephone number, specify the entire telephone number such as
"0312345678".
„ Gateway Address
Enter the IP address of the VoIP gateway.
T.38 Settings
Configure the settings for T.38.
T.38 Transport Protocol
Select T.38 transport protocol from [TCP] or [UDP].
Note • When you use VoIP gateway manufactured by Cisco Systems, Inc., select [UDP].
T.38 - UDPTL Listening Port Number
Set the UDPTL listening port number from 1 to 65535.
Important • Do not use any numbers assigned to other ports.
T.38 - TCP Listening Port Number
Set the TCP listening port number from 1 to 65535.
Important • Do not use any numbers assigned to other ports.
T.38 - RTP Listening Port Number
Set the RTP listening port number from 1 to 65535.
Important • Do not use any numbers assigned to other ports.
Prioritize T.38 IP Packets
Set the priority of IP packet transmission from 0 to 255.
Note • The value set varies depending on your environment. Consult your network administrator.
• Set the value already specified by the network side. If you set other values, the priority does
not change.
(For most of Cisco routers, speech traffic is set to 184(ef). If you change the value, consult
your network administrator.)
Outgoing/Incoming E-mail Settings
Set e-mail transmission and reception settings.
POP3 Server Settings
Set the POP3 server. In [POP3 Server Settings], you can set the following items:
Note • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value
from 0 to 255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where
"xxxx" is a hexadecimal value.
• When you make an entry mistake, press the <C> (Clear) button and enter again.
„ Server Name/IP Address
Enter a server name or IP address with up to 128 characters, and then select [Save].