Fuji Xerox ApeosPort-II C3300, User Manual

Page: 312 / 635

10 System Settings
310
System Settings
10
Edge Erase
Set the default value for [Edge Erase] in the [Layout Adjustment] screen. You can select from
[Normal] or [Edge Erase].
Edge Erase - Top & Bottom Edges
Set the default value for the amount of edges erased from the original in the top and bottom
directions in [Edge Erase] in the [Layout Adjustment] screen. Specify a value from 0 to 50 mm
in 1 mm increments.
Edge Erase - Left & Right Edges
Set the default value for the amount of edges erased from the original in the left and right
directions in [Edge Erase] in the [Layout Adjustment] screen. Specify a value from 0 to 50 mm
in 1mm increments.
Center Erase/Binding Erase
Set the default value for the binding erase amount of the original in [Edge Erase] in the
[Layout Adjustment] screen. Specify a value from 0 to 50 mm in 1 mm increments.
Image Compression
Set the default value for [Image Compression] in the [Output Format] screen.
E-mail Subject
Set the default value for the e-mail subject. Up to 128 characters can be entered for the
subject.
Scan to PC Defaults
You can select the default protocol (transfer protocol) used for transfer from FTP, SMB,
and SMB (UNC Format).
Original Size Defaults
Set the original size shown in [Original Size] in the [Layout Adjustment] screen. An
original size is assigned to each of the 11 buttons other than [Auto Size Detect].
When frequently scanning non-standard size originals, by presetting the non-standard
size, you can save time to enter the original size each time a document is scanned.
„ A/B Series Size
Select from 10 sizes of A and B series.
„ Inch Size
Select from 12 sizes of inch series.
„ Others
Select from other 13 sizes.
„ Variable Size
You can enter any size. Set the width (X) from 15 to 432 mm, and the height (Y) from 15 to
297 mm in 1 mm increments.
Output Size Defaults