INZ-TN7ZSS-E
- 23 -
4.8 Piping system diagram
Fig. 4
－
9
(10) Control unit fixed fixture
(11) Display part
(5) Bolt for angle fine
adjustment
(12) External input/output part
0.5 to 10m
(0.5 to 5m) Note2
(1) Receiver box
(120×180×100)
(2) Transmitter box
(160×240×100)
(160×320×100) Note2
(6) Purging gas
inlet
Receiver unit
Transmitter unit
(8) Cable between receiver unit and
transmitter unit (standard : 2m)
(4) Flange of angle
adjustment
Flange pipe to
mount stack
(not suppried)
JIS10K50A FF
(with packing)
Stack
(9) Cable between receiver unit and control unit (standard : 5m)
Control unit
Power
supply
Filter regulator (option)
Mist separator
(option)
Note 1
Instrumentation
air inlet
2-Flowmeter
(option)
20 to 100L/min
Copper or SUS pipe (not supplied)
Instrumentation airline joint (not supplied)
Or air-set box
Note 1: Be sure to set the R1/4 sealing
plug (ZZP*ZSSTK738114P7)
on the drain outlet of the mist
separator.
Note 2: Diameters for CO + O
2
meter
DI/O
A
O
A
I
Connector
Cable length
(200mm)
7-Waterproof grand (Internal diameter ø12)
Mounting diagram
ZS S
LASER GAS ANALYZER
Be sure to prepare instrument air or N
2
gas.
(Instrument air should not contain oil and mist)
If mixed air such as oil and mist contained is used,
contamination occurs in the pipe of flow meter and purge
flow rate falls, which will affect the measurement.
According to above, maintenance is required frequentlyand
filter may be installed additionally depending on situation.
Note) Air or nitrogen purge should be performed if the equipment is
installed in a flue whether or not it is operated. n case operate the flue
without performing purge, it may cause the fatal damage to the optical part.
ø10/8 Teflon pipe
(not supplied)
(4) Flange of angle
adjustment
(7) With bolt and nut
(M16×55)
(6) Purging gas inlet
(with bell-and-spigot
joint for ø10/8)
Summary of Contents for ZSS-7
Page 1: ......
Page 109: ...102 INZ TN7ZSS E APPENDIX 2 CODE SYMBOLS...
Page 114: ...INZ TN7ZSS E 107 13 BNC cable for optical axis adjustment...
Page 116: ......
