Fuji Electric Time Delta-C FSV-2, Instruction Manual

Page: 67 / 149

-60-
4.12.5. Damping
Description
 Used for attenuating the variation of measured value.
A time constant is set (response time of about 63%).
Settable range: 0.0 to 100.0sec in 0.1 sec steps
Note) In case you set to 0 sec, response time become as below.
 System cycle 0.2sec
 Dead time 0.2sec or less, time constant 0.1sec
Channel designation : CH1, CH2, CH ALL
* When using 2-pipe measurement, configure both CH1 and CH2. CH1 and CH2 can be configured
simultaneously by selecting CH ALL.
* No channel setting is necessary for 1-path/energy measurement and 2-path measurement.
For actual keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.5.1.)
Operation
(example) Change the damping from 5 to 20 sec.
* Below is an example for 1-path/energy measurement and 2-path measurement. Refer to Section 4.8.1 for channel
designation of 2-pipe measurement.
Key operation Description Display
▼
Press the key twice to display “OUTPUT SETUP”.
OUTPUT SETUP
ENT
▼
Press the
ENT
key once to display “ZERO ADJUSTMENT”.
ZERO ADJUSTMENT
SET ZERO
▼
Press the key once to display “DAMPING”.
DAMPING
5.0 sec
ENT
▼
Press the
ENT
key once to blink the cursor.
DAMPING
0 05.0 sec
0 0 5.0 sec
0 2 5.0 sec
02 5 .0 sec
▼
Set “20” by the key and the key.
DAMPING
02 0 .0 sec
Press the
ENT
key once to register.
DAMPING
 COMPLETE 
↓
ENT
▼
▼
▼
▼
――― DAMPING has been registered. ――― DAMPING
20 sec
ESC
Press the
ESC
key once and then press the key for 3 times to enter
the measurement mode.
0.000 %
0.000 m3