Fuji Electric Time Delta-C FSV-2, Instruction Manual

Page: 47 / 149

-40-
4.11.3. Flow total unit
Description
 Select the unit of total volume.
 Metric system
Channel designation : CH1, CH2, CH3
* When using 2-pipe measurement, set all of CH1, CH2, and CH3.
* No channel setting is necessary for 1-path/energy measurement and 2-path measurement.
Flow total unit · mL, L, m
3
(factory set), km
3
, Mm
3
, mBBL, BBL, kBBL
<Note> First, set the unit system (metric) according to Section 4.11.1.
Set the total mode to “STOP” before setting this parameter. (See Section 4.12.2.)
For actual keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.5.1.)
Operation
(example) Set a flow total unit to “L”.
* Below is an example for 1-path/energy measurement and 2-path measurement. Refer to Section 4.8.1 for channel
designation of 2-pipe measurement.
Key operation Description Display
▼
Press the key for 3 times to display “MEASURE SETUP”.
MEASURE SETUP
ENT
▼
Press the
ENT
key once to display “MEASUREMENT MODE”.
MEASUREMENT MODE
1 PATH
▼
Press the key 3 times to display “TOTAL UNIT”.
TOTAL UNIT
m3
ENT
▼
Press the
ENT
key once to blink the cursor.
TOTAL UNIT
m3
▼
Press the key twice to display “L”.
TOTAL UNIT
L
Press the
ENT
key once to register.
TOTAL UNIT
 COMPLETE 
↓
ENT
▼
▼
▼
▼
――― “L” has been registered. ―――
TOTAL UNIT
L
ESC
Press the
ESC
key once and the key twice to return to the
measurement mode.
0.000 L
0.000 L/min