— 13 —
Parameter
display code
Description
Setting range(setting unit) Reference
P
ProG
I
D
AL
AH
TC
TC2
Cool
db
STAT
SV-1
to
SV-4
TM1r
to
TM4r
TM1S
to
TM4S
MOD
HYS
Hb
AT
–100.0 to 100.0%
0.0 to 100.0%FS (engineering unit)
bAL
Ar
Loc
Note 5, *3
Note 5, *6
*5
*5
*4
*4
*1
*1
*1
*1
*1
0.0 to 999.9%FS
oFF:Local operation
rUn : Start of program operation
HLd : Pause of program operation
End : End of program operation
0 : Not performed
1 : Performed in the standared mode
2 : Performed in the low PV mode
0 : enables the change of setting for
all paramater
1 : disable the change of setting for
all paramater
2 : enables the setting of a set value
(SV) only
0.0 to 999.9 sec.
0.0 to 50.0 A
0.0 to 100% FS(enginering unit)
0.0 to 100% FS(enginering unit)
0 to 3200 sec.
Manual reset value
Anti-reset wind up
Key lock
Proportional band (ON/OFF control at 0.0)
Ramp soak command
Derivative action time
Alarm 2 setting value
Alarm 1 setting value
Integral action time
Proportional time cycle of control output 1
Proportional time cycle of control output 2
Proportional band coefficient on the cooling side
Shifting the proportional band on the cooling side
The current position of the program
Ramp SV mode
Segment time in the 1st ramp
to
Segment time in the 4th ramp
Segment time in the 1st soak
to
Segment time in the 4th soak
Target value in the 1st ramp
to
Target value in the 4th ramp
0 to 50%FS (engineering unit)
1 to 150 sec.
1 to 150 sec.
0.0 to 100.0 times
-50
to
50% (MV)
0:00 to 99:59
0:00 to 99:59
0 Note 1
0 to 100%FS (engineering unit)
Can not be set
to
to
to
Insensitive zone
Auto-turning
Heater burnount alarm setting value
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
