2-30
2. Local Mode Screen
7.
LAN Unit Setting
(Only with the CUR-03 Communication I/F Unit Installed)
Pressing [LAN Unit Setting] in the menu icons brings up the LAN Unit Setting screen.
This screen is used to set the IP address for the CUR-03 communication I/F unit installed on the V9
series unit.
Details of the LAN Unit Setting screen are the same as “LAN Setting” (page 2-12).
7-1.
IP Setting
This is the same as “IP Setting” (page 2-13) of “LAN Setting”.
(The default IP address is “192.168.3.1”.)
IP Address Setting for the LAN Unit
Setting on the V9 Unit
This is the same as “Setting on the V9 Unit” (page 2-14) of “LAN Setting”.
Setting Using the V-SFT Editor
1. Select [System Setting]
[Ethernet Communication]
[Local Port Address] on V-SFT.
The [IP Address Setting] window is displayed.
Menu icons
LAN Unit Setting screen
• Set an IP address in a different network group from that for the following:
- [LAN Setting] / [LAN2 Setting] (only for additional wired LAN I/F models)
- [WLAN Setting] (only for wireless LAN I/F models)
- [LAN Unit Setting] (only with the CUR-03 communication I/F unit installed)
If set in the same network group, the system will not operate correctly.
• Set a gateway for only one of the following:
- [LAN Setting] / [LAN2 Setting] (only for additional wired LAN I/F models)
- [WLAN Setting] (only for wireless LAN I/F models)
- [LAN Unit Setting] (only with the CUR-03 communication I/F unit installed)
If multiple gateways are set, the system will not operate correctly.
