20
Connection
Connecting to Input/Output Terminal Block
Use a micro driver from Product accessories to connect the connector.
If a micro driver other than Product accessory is used, said driver must be within 2.5 mm
in width and 0.4 mm in thickness.
Load Cell Terminal and External Input/Output Terminal
1. Strip wire 7 to 8 mm and twist it enough not to untwist the wire end.
Applicable wires are 0.13 to 1.0 mm
2
(AWG28 to 18).
2. Insert accessory micro driver into the square hole located either above or under the
wire insertion hole while directing the driver in the direction shown in the figure.
Then, a metal piece that closes the wire insertion hole opens.
3. Insert the wire in the insertion hole without untwisting the wire end.
4. Pull out the micro driver.
5. Slightly pull the wire to confirm the wire has been firmly clamped.
6. Insert the connected plug to IN-100 and fix it with screws.
Driver insertion hole
Electric wire insertion hole
Connector
Micro driver
Electric wire
