- 4 -
2. Stroke Adjustment
Adjust the lower stroke of the press ram by adjusting the mechanical stopper. First loosen the cap
screw on the upper section of the stopper. The stopper itself is threaded and will turn. (Turn the
stopper clockwise to shorten the press ram stroke.) After adjusting the stopper position, tighten the
cap screw again. Make sure to reinstall the acrylic safety cover after making adjustments.
Example of when to use the mechanical stopper:
1) To prevent the press from hitting bottom if no workpiece is present.
2) Set the press fit dimension (thickness) of a workpiece by adjusting the press stroke.
3. Adjust the Press Output and Lowering Speed
1) The press output can be adjusted by adjusting the regulator. See "Preparation" on page 3.
CAUTION
Do not make the press output larger than the maximum load that the load cell
is rated for. Overloading the load cell may permanently deform it or break it.
2) The lowering speed of the press ram can be adjusted using the lowering speed controller.
Devices listed below are available as options for our pneumatic presses. Please contact
us for more information.
1.Timer Box
