49 - 70
71130/11E/0318
Command MD
<id>MD>>para5>
Measuring interval of the complete wind measurement (Measurement Delay).
Access:
Configuration mode (ADMIN).
Description:
Specifies the time in increments of 10ms from the start of one measuring cycle (4 TOF)
to the start of the next. In standard mode the time is 20ms so that a complete data
record is generated from all sensors every 20ms.
Value range:
0..30000
Initial value:
2
Command NC
<id>NC<para5>
North Correction of the wind direction and direction of brightness.
Access:
Configuration mode (ADMIN).
Description:
With the north correction a constant angle is added to the measured wind direction.
The parameter is used to correct electronically a possible alignment error subsequently
after mounting. If the WEATHER STATION, for example, is not aligned directly to north
but to northeast, the wind direction always indicates 45° too little. In this case a north
correction of 45 must be set.
North correction influences the wind directions output in the data telegrams as well as
the analogue output values.
Parameter description:
1000 : Automatic north correction via magnetic compass (optional), see also
command MC
.
0..359: Set north correction in °.
Value range:
0..359 / 1000
Initial value:
0
Command OL
<id>OL<para5>
Output link (Output Link).
Access:
Configuration mode (ADMIN).
Description:
This command can be used to link optional measured values to the analogue outputs
4-8.
Parameter:
1:
Linked to relative humidity.
2:
Linked to air pressure.
3:
Linked to brightness from north.
4:
Linked to brightness from east.
5:
Linked to brightness from south.
6:
Linked to brightness from west.
7:
).
8:
Linked to direction of brightness or resp. azimuth (see command DO).
9:
Linked to precipitation intensity or precipitation status, see command AP.
0:
Linked to precipitation sum.
The position of the parameter from left to right describes the numbers 4-8 of the
relevant output.
