CC186-499 TWO-SIDED SYSTEM CLOCK
REV 10/06/00
FUTURE TECHNOLOGY RESOURCES, LTD.
PAGE 3
SIGNAL WIRING: A signal cable with phone plug and DB9 female connector are provided.
The phone plug end connects to the Signal jack located on the side panel. The other end of
the cable has a DB9 female connector for connection to the host device.
POWER WIRING: A power module is provided for powering the CC186-499. Plug the
power connector from the power module into the 12VAC Power jack on the side panel. The
other end of the power module can be plugged into a standard 120 VAC power outlet.
BE SURE ALL SYSTEM WIRING IS COMPLETE
BEFORE APPLYING POWER TO THE CC186-499.
OPERATION
Apply power to the CC186-499 by plugging the power module into the 120 VAC power outlet.
The remote display will be blank. The ON/OFF button must then be pressed to turn on the
display. The digits will then show “--:--:--“. The display is now ready to receive the time data
(10-byte message) from the host device. The display may be turned ON and OFF by
pressing the button on top of the unit. While OFF the display will maintain the correct time as
long as the power is not disconnected from the unit.
TECHNICAL SUPPORT
For any questions concerning installation and operation of this product, contact our factory
at: PHONE (800) 444-7161 or FAX (318) 797-4864.
Accessories Included
Power and Signal Jacks
