FSR
244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: 973.785.4347 - Fax: 973.785.4207
43246
LIT1667
1. WIRING CAN BE DONE DURING OR AFTER INSTALLATION. SEE CUSTOMER
SPECIFICATIONS FOR LOCATING WM-CMPT. ORIENT AS REQUIRED SO THAT
THE WIREWAY AND WIREWAY OPENING IS BEST ACCESSED FOR
SERVICABILITY. ENSURE WIREWAY DOORS ARE NOT OBSTRUCTED.
WM-CMPT Installation Instruction
PUSH WIREWAY UP TO MOUNTING BRACKET UNTIL IT STOPS.
4a.
(2) BOOT HALF
ALIGN GROOVE IN BOOT
WITH GROOVE ON WIREWAY
GROOVE ON WIREWAY
TO TABLE
UNDERSIDE
TUBE WIREWAY
SHOWN OPEN
MOUNTING BRACKET
LABEL ON OTHER SIDE
INDICATING WIREWAY
MOUNTING SIDE
5. INSTALL AND ROUTE ALL WIRING AS DESIRED/NECESSARY,
BEFORE CLOSING AND LATCHING THE SIDES OF THE WIREWAY
(WIRING CAN ALSO BE INSTALLED AT A LATER DATE).
a.
c.
b.
4b. PUSH PLATE WITH STANDOFFS TOWARDS TONGUE SO THAT
WIREWAY WILL HANG UNASSISTED.
4c. TIGHTEN SCREWS TO SECURE WIREWAY TO MOUNTING
BRACKET.
OPENING TO WIREWAY
6. WITH WIREWAY CLOSED, INSTALL BOOT HALVES AND SLIDE
DOWN TO MEET FLOOR. REMOVE "LOOP PAD" FOR CARPETED
FLOORS, AND REMOVE JUST THE ADHESIVE PROTECTOR FOR
NON-CARPETED FLOORS.
TONGUE
HOOK
LOOP
ADHESIVE
PROTECTOR
