SW-STK-1P1D STICK ASSEMBLY INSTRUCTIONS
244 Bergen Boulevard, Woodland Park, NJ 07424, Phone 973.785.4347 - Fax: 973.785.4207
Patent No. 10,862,283
STEP 1:
Install the plastic raceway edges in the track base.
1.
Install in the outer track as shown.
2.
Have the plastic edge hang out one side by 3 or 4 inches.
3.
Tap the edges in with rubber mallet or bottom of a rubber coated hammer handle.
STEP 2:
Next, press the wired device box onto the extended plastic edging with the cord facing onto the track,
then slide the device box tabs into the bottom slot on the track base only an inch or two.
Alignment
Rails
Device
Box Tabs
STEP 3:
Run the power cord down the length of the raceway and out the end opposite the device box. Add
any additional low voltage wires required by feeding them through the brush on the device box. Insert
wiring clips as required (5 provided) to hold the wires in place.
Wiring Clip
User Supplied Low Voltage Cable
43431
LIT1823
A
3"-4"
1
2
3
