S5860-24XB-U SWITCH RESET AND RECOVERY SYSTEM CONFIGURATION GUIDE
www.fs.com
2
Manually power off and restart the device. When prompted by Ctrl+C, press the Ctrl key C key on the keyboard at the same time to enter
the u-boot interface. Under the Rboot menu, click the red reminder below to enter the address configuration menu
U-Boot 1.4.2--gf4b0786 (Nov 01 2018 - 09:52:06 +0800)
I2C:
ready
DRAM: 1 GiB
NAND: 1024 MiB
Loading Environment from SPI Flash... SF: Detected s25fl128s_64k with page size 256 Bytes, erase size 64 KiB, total 16 MiB
OK
Press Ctrl+B to enter Boot Menu, Press Ctrl+C to enter Rboot 0
====== Rboot Menu(Ctrl+Z to upper level) ======
Scattered utilities.
************************************************
0. Tftp utilities.
1. X/Y/ZModem utilities.
2. Run main.
3. SetMac utilities.
4. Scattered utilities.
************************************************
Press a key to run the command: 4
====== Rboot Menu(Ctrl+Z to upper level) ======
Scattered utilities.
************************************************
0. Show Version.
1. Reload System.
2. Set Baudrate.
3. Format Flash.
4. Exit menu.
************************************************
Press a key to run the command: 4
data # cd /mnt/data
------>Enter the data directory
data #vi config.text ------>Enter the config.text file
Use the up, down, left and right keys of the keyboard to move the cursor, find the corresponding password configuration, press dd twice
in succession, delete the entire line of commands, and finally press esc, enter: wq, exit the save file, and then just reboot. If you delete the
wrong configuration, press esc, enter: q! to force quit the document, and then enter the document with vi config.text.
1.3.2 U-boot Restore Factory Settings Reset Password
Manually power off and restart the device. When the Ctrl+C prompt appears, press the Ctrl key C key on the keyboard at the same time to
enter the u-boot interface. Under the Rboot menu, click the red reminder below to enter the address configuration menu
U-Boot 1.4.2--gf4b0786 (Nov 01 2018 - 09:52:06 +0800)
I2C:
ready
DRAM: 1 GiB
NAND: 1024 MiB
Loading Environment from SPI Flash... SF: Detected s25fl128s_64k with page size 256 Bytes, erase size 64 KiB, total 16 MiB
OK
Press Ctrl+B to enter Boot Menu, Press Ctrl+C to enter Rboot 0