FS M6500 Series, Configuration Manual

Page: 161 / 185

M6500 Series NE Configuration Manual
160
untrustworthy to trustworthy and the running time counts again from 0. All the details updated to the latest
time to read the value.
Figure9-42 OTUk/ODUk Successfully Reset
9.2.4.5. OTUk/ODUk Monitoring Data Shown As“-”
Here are the situations when the OTUk/ODUk monitoring data for the port is shown as -:
(1) When optical module is not inserted into the port, the optical module is not in position but the port is
enabled.
(2) The port and the module are normal and the port is enabled.
(3) Optical module is inserted into the port but it is mismatched and the port is enabled.
At this time, all the data will be shown as -. The suspicious interval marker is trustworthy or untrustworthy (after
900/86400 seconds). The running time is normal and counts from 0, as shown in the figure below:
Figure9-43 Optical Module of OTUk/ODUk Not In Position
Here are the situations when the monitoring data for the board is shown as -:
(1) When the board is not in position or is pre-configured with an empty slot and the port for the board is
enabled, all the data will be shown as -.The suspicious interval is marked as untrustworthy, and the running time
is always 0 without any change, as shown in the figure below.
Figure9-44 OTUk/ODUk Monitoring Data
(2) When the board is mismatched and the port for the board is enabled, all the data will be shown as -. The
suspicious interval is marked as untrustworthy, and the running time counts from 0 without any change, as
shown in the figure below: