M6500 Series NE Configuration Manual
147
Figure9-5 No Modification of Monitoring Point Status
9.1.4. Disable Performance Monitoring Point
When the current 15-minute performance monitoring point is disabled, the 24-hour performance monitoring
will be automatically disabled by default, and all the performance monitoring parameters of the performance
monitoring point will be disabled at the same time. Therefore, when the performance monitoring point is
disabled, the relevant data of the current performance statistics can not be viewed, as shown in the figure
below:
Figure9-6 Disable Monitoring Point
Each monitoring point can be disabled by modifying the status of the monitoring point with the button behind
it (Enable PMP - >Disable PMP)
,
as shown in the figure below:
Figure9-7 Disable A Single Monitoring Point
To realize batch disabling operations on multiple pieces of data, you can select the previous multiple
checkboxes, then click the button on the table (Disable PMP) to disable the monitoring of selected
performance,as shown in the figure below:
Summary of Contents for M6500 Series
