M6500 Series NE Configuration Manual
144
9. Performance Management
The first step of performance management is to enable the performance monitoring point to be monitored in
the performance monitoring point management interface.
9.1. Performance Management Introduction
9.1.1. Filter Box
Click on "
Configuration
" on the top menu bar and select“
Performance Monitoring
”, as shown in the figure
below:
Figure9-1 Performance Monitoring Point Management Interface
Check the status of the corresponding monitoring point through the above filter box. The filter conditions
include network element, slot, port, PM monitoring cycle, performance monitoring status. (There are three kinds
of monitoring status: enable, disable and all. The three kinds of monitoring status can be viewed separately.) For
all filter conditions, when any of them is selected, you can get the corresponding information by clicking “
Query
”
in the middle part, as shown in the figure below.
Figure 9-2 Show Monitoring Management Information
9.1.2. Performance Monitoring Point Introduction
The performance monitoring point is determined by monitoring point ID, monitoring point location,
monitoring point direction and monitoring cycle.
Performance monitoring point location: far end and near end (for OTUk and ODUk).
Near-end monitoring point: according to received BIP8.
Summary of Contents for M6500 Series
