Thank you for purchasing FrSkyCurrent Sensor – FAS100 ADV. It is designed for FrSky Smart Port enabled system,
and can measure Current (A) and Battery Voltage (V) when connected between a Battery and ESC and it has two
temperature sensors. In order to fully enjoy the benefit of it, please read the instruction manual carefully and set up
the device as described below.
Introduction
FrSky Electronic Co., Ltd. www.frsky-rc.com Contact us: [email protected]
Add: F-4,Building C, Zhongxiu Technology Park, No.3 Yuanxi Road, Wuxi, 214125, Jiangsu, China Technical Support: [email protected]
Version
1.0
Instruction Manual for FrSky
Current Sensor — FAS100 ADV
Note: All instructions, warranties and other collateral documents are subject to change at the sole
discretion of FrSky Electronic Co., Ltd. For further information, please visit www.frsky-rc.com
and click the support tab for this product.
Specifications
• Dimension: 65×23×18mm (L×W×H)
• Weight: 30g
• Measurement range: 0~100A
• Current consumption: 16mA@5V
• Maximum safe current: 100A
• Maximum battery voltage: 14S
• Compatible: FrSky Smart Port enabled receivers
• Connector: XT90 Anti spark
Warning: Install FrSky Current Sensor – FAS100 ADV on any appropriate surface of the airframe that
stays away from water, vibration, or fuel.
Bat
To other FrSky
S.Port Enabled Sensor
RECEIVER
XT 90
XT 90-S
ESC
TEMS
FBUS
To the S.Port of
FrSky receivers
FrSky Current Sensor – FAS100 ADV
is compatible with FrSky Smart Port enabled receivers. For more details,
please refer to corresponding receiver instruction manual.
Set Up
Connect the output Port of the sensor to the receiver, select Smart Port on the receiver setup screen, the sensor will
automatically recognize.
Protocol switching
Overview
TEMS
Measured Range:
TEMS :
-55℃~250℃ / -67℉~482℉
Deviation: ±5%
XT 90
XT 90-S
FBUS
23 mm
65 mm
