Version
1.0
Instruction Manual for FrSky
Current Sensor — FAS40 ADV
FrSky Electronic Co., Ltd. www.frsky-rc.com Contact us: [email protected]
Add: F-4,Building C, Zhongxiu Technology Park, No.3 Yuanxi Road, Wuxi, 214125, Jiangsu, China Technical Support: [email protected]
Connect the output Port of the sensor to the receiver, select Smart Port on the receiver setup screen, the sensor will
automatically recognize.
Protocol switching
Note: All instructions, warranties and other collateral documents are subject to change at the sole
discretion of FrSky Electronic Co., Ltd. For further information, please visit www.frsky-rc.com and
click the support tab for this product.
Thank you for purchasing FrSky Current Sensor – FAS40 ADV. It is designed for FrSky Smart Port enabled system,
and can measure Current (A) and Battery Voltage (V) when connected between a Battery and ESC. In order to fully
enjoy the benefit of it, please read the instruction manual carefully and set up the device as described below.
Introduction
Specifications
• Dimension: 65.24×15.7×16.6mm (L×W×H)
• Weight: 16g
• Measurement range: 0~40A
• Current consumption:16mA@5V
• Maximum safe current: 40A
• Maximum battery voltage: 6S
• Compatible: FrSky Smart Port enabled receivers
• Connector: XT60 Anti spark
Warning: Install FrSky Current Sensor – FAS40 ADV on any appropriate surface of the airframe that
stays away from water, vibration, or fuel.
FrSky Current Sensor – FAS40 ADV
is compatible with FrSky Smart Port enabled receivers. For more details,
please refer to corresponding receiver instruction manual.
Set Up
FBUS
Bat
ESC
To the S.Port of
FrSky receiver
RECEIVER
To other FrSky
S.Port Enabled Sensor
Overview
FBUS
15.7 mm
65.24 mm