Lotus Fountain
ASSEMBLY INSTRUCTIONS
(please also see photos on 2
nd
page)
1. Determine location for fountain and make sure area is level.
2. Pump and hose assembly must be done before placing fountain against the wall.
3. Unpack pump, attach the suction cups to its feet, place rubber ring / gasket over the threaded adaptor
and screw it into threaded hole at the top of pump (photo A).
4. The accessories bag including 4pcs screws / 1 set of flexible
hose with flow rate control valve /
1 pc round steel cover / 1pc spanner, (photo B)
5.
Adjust flow rate to achieve the desired effect and to minimize any splashing, Splashing can
occur if the flow rate is too high or the reservoir is too full. The flow rate can be increased or
decreased by moving the flow rate control valve on the flexible hose . Moving the valve
clockwise, will increase the flow rate and moving counterclockwise will decrease it.(photo C)
6.Connect the long flexible hoses with top fountain (photo D )
7. Take out the pump plug from outlet of bottom fountain(photo E)
8.Connect the pump with the short flexible hose (photo F)
9. Place the top fountain onto the bottom (photo G)
10.Lock 4 screws on the corners on the bottom fountain by spanner (photo H)
11. Fill the reservoir at least 85% full with clear / cool water. Always make sure the water can
submerge the pump completely to work properly and prevent the pump damage.
and put the round steel cover. (photo I)
12.Turn the switch on and the water will start to flow in minutes.
