Fronius WF 25i Case D200, Operating Instructions Manual

Page: 39 / 68

Before installation and commissioning
Safety
WARNING!
Danger due to incorrect operation and incorrectly performed work.
This can result in severe personal injury and damage to property.
▶
All the functions described may only be used by trained and qualified personnel.
▶
Fully read and understand this document.
▶
Fully read and understand all the Operating Instructions for the system components,
especially the safety rules.
Proper use The device is intended exclusively for wire feeding in MIG/MAG welding in conjunction
with Fronius system components.
Utilisation for any other purpose, or in any other manner, shall be deemed to be not in
accordance with the intended purpose.
The manufacturer shall not be held liable for any damages arising from such usage.
Proper use includes:
-
carefully reading these operating instructions
- following all the instructions and safety rules in these operating instructions
- performing all stipulated inspection and maintenance work
Setup regulations
WARNING!
If one of these devices falls or topples over, it could cause serious or even fatal
injury.
Place all system components, upright consoles and trolleys on a solid, level surface in
such a way that they remain stable. If a swivel pin holder is being used, always make
sure that the wire-feed unit is seated securely on the swivel pin of the swivel pin holder.
The device is tested to IP 23 protection, meaning:
-
protection against penetration by solid foreign bodies with diameters exceeding
12.5 mm (0.49 in.).
- protection against direct sprays of water at any angle up to 60° from the vertical
The device can be set up and operated outdoors in accordance with IP23. Avoid direct
wetting (e.g. from rain).
39
EN