Fronius Wattpilot Go 11 J 2.0, Operating Instructions Manual, Page: 53 / 72

Cable release Standard mode
The charging cable at the charging station remains locked after completion of
the charging process until the charging cable is disconnected from the vehicle
(anti-theft protection).
Auto-unlock
The charging cable is only locked during charging.
Always locked
The charging cable on the Wattpilot is always locked. Switch to standard mode to
unlock.
Unlock in case of power failure
The charging cable is unlocked in the event of a power failure. By default, the
charging cable remains locked in the event of a power failure for reasons of theft
protection. To unlock the charging cable, the Wattpilot must be supplied with
power again.
Earthing test Activation or deactivation of the earthing test. It is necessary to deactivate the
earthing test in insulated grids in some countries (e.g. Norway).
ID chips Up to 10 ID chips can be used. The ID chip is used for authentication and for re-
cording user-specific charging amounts.
NOTE!
One ID chip can be taught in for several Fronius Wattpilot devices.
Learn ID chip
1
Hold the ID chip in front of the card reader of the Wattpilot.
2
Click on "Teach in ID chip" in the app.
Renaming an ID chip
1
Tap the corresponding entry.
2
Enter the desired name and tap "Save".
NOTE!
The ID chips and the charging amount remain stored in the event of a reset.
Password The password protects against unauthorised access to the Wattpilot.
Password guidelines
- At least 10 characters
- At least three of the following four strings: Upper case letters, lower case
letters, numbers, special characters
- No umlauts (ä, ö, etc.)
- No paragraph sign (§)
Technician password
If the technician password is activated, it is required to access "Grid settings".
53
EN