Fronius Wattpilot Go 11 J 2.0, Operating Instructions Manual, Page: 51 / 72

- Choose car: For activating the optimised standard settings of different
vehicle models.
- Minimum current: Some cars will not resume charging after an interruption.
To prevent an interruption, the minimum charging current can be set.
- Forced charging interval: In the case of cost-optimised charging, the Wattpi-
lot interrupts the charging process if the electricity price is too high. Some
cars will not tolerate interruptions and will not continue charging after pro-
longed interruptions to the charging process. In this case, the charging pro-
cess must be started regularly for a short time.
- Allow charging pause: Some cars will not resume charging after an interrup-
tion. Charging interruptions are prevented if this option is deactivated.
- Simulate unplugging: Some cars need to be disconnected for a while if there
has been an interruption during cost-optimised charging. This function simu-
lates a disconnection before charging continues.
- Charging pause : Some cars require a certain amount of time after an inter-
ruption to charging before they can start charging again.
- Minimum charging time: Set the minimum time for which the car must be
charged after charging starts.
- Choose phase switch:
- Automatic: A power level can be set, from which 3
‑
phase charging takes
place. If "0" is set, the Wattpilot immediately starts 3
‑
phase charging.
- Only 1 ‑ phase: There is 1 phase available for charging.
- Only 3 ‑ phase: There are 3 phases available for charging.
- 3 ‑ phase power level: Set a power level that must be reached by the photo-
voltaic system before the Wattpilot switches from 1
‑
phase to 3
‑
phase char-
ging. If the available power is greater than the set value, the Wattpilot imme-
diately activates 3
‑
phase charging. Automatic switching can be deactivated in
the car settings.
- Phase switch delay : Phase switching is performed when the "3-phase power
level" is permanently exceeded or undercut during this period.
- Phase switch interval : Minimum time between phase switching.
NOTE!
If a vehicle to be charged is not listed, no specific charging behaviour is known.
All defaults can be customised.
▶
Select the standard charging behaviour.
Charging timer The "Charging timer" setting limits charging to specific times. A start and end
time must be specified for this. Several time windows can be set. The following
can be set:
- The time (start and end time) and
- The days of the week.
NOTE!
Verhalten bei aktiviertem Eco Mode or Next Trip Mode:
If charging is not allowed by the charging timer for a certain period of time, Eco
Mode and Next Trip Mode are also blocked for this period.
If the charging timer does allow charging in a certain period of time but the set-
tings for Eco Mode or Next Trip Mode are not met, charging will not occur.
Name Change the name of the paired Wattpilot.
51
EN