Fronius TransSteel 3000c Pulse, Operating Instructions Manual

Page: 82 / 140

TIG welding
CAUTION!
Danger of injury and damage from electric shock.
When the power switch is switched to position - I -, the tungsten electrode of the welding
torch is live.
▶
Ensure that the tungsten electrode is not touching any people or electrically conduct-
ive or grounded parts (housing, etc.).
1
Set the power switch to position - I -: all indicators on the control panel briefly illumin-
ate
2
Press the "Process" button to select the TIG welding process:
The welding voltage is applied to the welding socket with a three second time lag.
IMPORTANT! Under certain circumstances, it may not be possible to change welding
parameters that have been set on the control panel of a system component - such as
wirefeeder or remote control - on the control panel of the power source.
3
Press the "Parameter selection" button to select the amperage parameter.
4
Use the selection dial to set the desired amperage.
The amperage value is shown on the left-hand digital display.
All the parameter set values set using the selection dial are saved until the next time
they are changed. This applies even if the power source is switched off and on
again.
5
Set the desired amount of shielding gas on the pressure regulator
6
Commence welding process (ignite arc)
82