Fronius TransSteel 2700c, Operating Instructions Manual

Page: 87 / 120

Changing welding parameters
1
Use the "Mode" and "Process" buttons or the left-hand adjusting
dial to select the required setup parameter
2
Change the value of the setup parameter using the "Parameter
selection" buttons or the right-hand adjusting dial
Exiting the Level 2 Setup menu
1
Press and hold the "Mode" button
2
Press the "Process" button
3
Release the "Mode" and "Process" buttons
Exiting the Setup menu
1
Press and hold the "Mode" button
2
Press the "Process" button
3
Release the "Mode" and "Process" buttons
Parameters for
MIG/MAG welding
in the Setup
menu level 2
C-C Cooling unit Control
(only with connected cooling unit)
Unit: -
Setting range: Aut, On, OFF
Factory setting: Aut
Aut: The cooling unit cuts out after a 2-minute welding off-time.
IMPORTANT! If the coolant temperature and flow monitoring options have
been installed in the cooling unit, the cooling unit cuts out as soon as the
return-flow temperature drops below 50 °C, but at the earliest after a 2-minute
welding off-time.
On: The cooling unit is always ON
OFF: The cooling unit is always OFF
IMPORTANT! If the FAC welding parameter is used, the C-C parameter is not
reset to the factory setting. If the MMA welding process is selected, the cool-
ing unit is always switched off, even if the switch is in the "On" position.
87
EN