Safety Instructions
General
The device has been manufactured using state-of-the-art technology and ac-
cording to recognized safety standards. If used incorrectly or misused, however,
it can cause
-
injury or death to the operator or a third party
-
damage to the device and other material assets belonging to the operating
company
-
inefficient operation of the equipment
All persons involved in the commissioning, operation, maintenance, and servicing
of the device must
-
be suitably qualified
-
have completely read and followed these operating instructions
The operating instructions must always be at hand wherever the device is being
used. In addition to the operating instructions, all applicable local rules and reg-
ulations regarding accident prevention and environmental protection must also
be followed.
All safety and danger notices on the device
-
must be kept in a legible state,
-
must not be damaged/marked,
-
must not be removed,
-
must not be covered, pasted, or painted over.
For the location of the safety and danger notices on the device, refer to the sec-
tion headed "General Information" in the operating instructions for the device.
Before switching on the device, eliminate any faults that could compromise
safety.
Your personal safety is at stake!
Environmental
conditions
Operation or storage of the device outside the stipulated area will be deemed as
not in accordance with the intended purpose. The manufacturer accepts no liab-
ility for any damage resulting from improper use.
For exact information on permitted environmental conditions, please refer to the
"Technical data" chapter.
Grid connection
Devices with a high output can influence the energy quality of the grid due to
their current consumption.
This may affect a number of device types in terms of:
-
Connection restrictions, requirements regarding maximum permissible grid
impedance
*)
or
-
criteria regarding the minimum required short circuit power
*)
*)
both at the interface with the public grid
See technical data
In this case, the operator or the person using the device should check whether or
not the device is allowed to be connected, where appropriate through discussion
with the grid operator.
6
