Fronius Robacta TSS /i, Operating Instructions Manual, Page: 83 / 100

Wire cutter -
cleaning end pro-
gram sequence
Inner gas nozzle cleaning brush
Move to position A
approx. 50 mm/1.97 in. above wire cut-
ter (between blades and sheet metal
cover)
Speed: High-speed mode
A
50 mm
1.97 in.
Set
"Start wirefeeding" signal on the power
source for approx. 2.5—4.5 seconds
(approx. 20% longer than retracting the
wire)
Wait 2.5 - 4.5
seconds
Reset
"Start wirefeeding" signal on the power
source
Move into wire cutter
insertion depth = x mm above the cut-
ting tool
x = stick out of the wire electrodes
depending on application
max. speed: 50 cm/min (19.69 ipm)
Set
external signal "Cut wire electrode"
Wait 0.5 seconds
Move straight up
approx. 50 mm/1.97 in. centrally above
wire cutter blades
Speed: 50 cm/min (19.69 ipm)
83
EN-US