Fronius Robacta TSS /i, Operating Instructions Manual, Page: 78 / 100

Inner gas nozzle
cleaning brush
program
sequence
Move to position F
1
approx. 50 mm/1.97 in. centrally above
the inner gas nozzle cleaning brush
Contact tip 1 vertical to the service sta-
tion
Speed: High-speed mode
50 mm
1.97 in.
F
Set
external signal "Internal valve brush
cleaning"
Move into the inner gas nozzle clean-
ing brush
max. speed: 50 cm/min / 19.69 ipm
max. insertion depth: 1/3 of the brush
length
Wait 2-3 seconds
Move to position F
2
approx. 50 mm/1.97 in. centrally above
the inner gas nozzle cleaning brush
Contact tip 2 vertical to the service sta-
tion
max. speed: 50 cm/min (19.69 ipm)
Move into the inner gas nozzle clean-
ing brush
max. speed: 50 cm/min / 19.69 ipm
max. insertion depth: 1/3 of the brush
length
Wait 2-3 seconds
Move to position F
approx. 50 mm/1.97 in. centrally above
the inner gas nozzle cleaning brush
Contact tip 2 vertical to the service sta-
tion
max. speed: 50 cm/min (19.69 ipm)
78