Fronius Robacta Reamer X-Line J, Operating Instructions Manual

Page: 42 / 76

Performing a full
adjustment
1
Fill the parting agent container with
parting agent
> 6 s
2
Hold the ‘OUT OFF’ key for at least 6
seconds
-
The LED on the sensor first
flashes slowly and then faster
after 6 seconds
- after releasing the ‘OUT OFF’ key,
the LED turns off once again - the
sensor has detected a high fluid
level
Unlocking/lock-
ing the fill-level
control sensor
10 s
10 s
NOTE!
To prevent the unintentional adjustment
of the fill-level control sensor, it is pos-
sible to lock the sensor.
Locking the fill-level control sensor:
1
Simultaneously press the ‘OUT OFF’ and ‘OUT ON’ keys for at least 10 seconds
-
The LED status briefly changes
•
if the LED is illuminated during locking, the LED briefly turns off after locking
• if the LED is not illuminated during locking, the LED is briefly illuminated
after locking
Unlocking the fill-level control sensor:
1
Simultaneously press the ‘OUT OFF’ and ‘OUT ON’ keys for at least 10 seconds
-
The LED status briefly changes
•
if the LED is illuminated during unlocking, the LED briefly turns off after
unlocking
• if the LED is not illuminated during unlocking, the LED is briefly illuminated
after unlocking
42