Fronius Robacta Reamer V Twin, Operating Instructions Manual

Page: 56 / 92

1. Wire cutter
NOTE!
Perform a complete cleaning cycle each time you start to weld.
Start
Start from position A
approx. 50 mm / 1.97 in. above wire
cutter (between the blades and the
metal cover)
Speed: high speed mode
A
50 mm
1.97 in.
Set
Signal to the power source "Start
wirefeeding"
Wait approx. 0.5 sec.
Reset
Signal to the power source "Start
wirefeeding"
Insert wire electrode into wire cut-
ter blade
Speed: 50 cm/min / 19.69 ipm
Set
External signal "Cut wire electrode"
Wait 0.5 sec.
Move straight up
approx. 50 mm / 1.97 in. above the
wire cutter blades
Speed: 50 cm/min / 19.69 ipm
Reset
External signal "Cut wire electrode"
Set
Signal to the power source "Retract
wire electrode"
56