Fronius Robacta Reamer V 70 Han12P, Operating Instructions Manual

Page: 28 / 76

Ensuring that the
cleaning device
is depressurised Attempt to briefly activate the cleaning device without any compressed air supply to
check whether the cleaning device is depressurised. To do this, proceed as follows:
1
Take protective measures:
-
The cleaning cutter, lifting device, gas nozzle clamping device, wire cutter and
parting-agent injection nozzle could start up. It is therefore important that you
keep your body, especially your hands, face and hair, any objects and all cloth-
ing away from the components referred to above
- Wear ear protection
- Wear protective goggles with side protection
2
Ensure that the cleaning device has been disconnected from the compressed air
supply
3
Briefly turn the "Start cleaning" screw on the cleaning device 90° to the right, then
turn it straight back to its original position
- If the cleaning device does not respond to the turning of the screw, the cleaning
device is depressurised
- If the cleaning device responds to the turning of the screw, the cleaning device
is still connected to a compressed air supply.
If this is the case, you must disconnect the cleaning device from the com-
pressed air supply and check again that the cleaning device is depressurised
before starting work
28