Fronius RC Pedal TIG /BT, Operating Instructions Manual

Page: 23 / 88

23
EN
Mode of opera-
tion Depressing the pedal equates to continually increasing the welding current.
Depending on the starting current time setup parameter, the remote control may be oper-
ated in the following ways:
Starting current time = off
Starting current, main current, reduced current and final current as well as the duration of
the currents are controlled solely by the welder actuating the pedal.
The further the pedal is depressed, the more current is available.
Starting current time = 0.01 - 30.0 s
- Starting current, UpSlope and starting current time are set on the power source.
- When the pedal is actuated, the welding process begins with the set starting current
and UpSlope.
- The main current is reached at the end of the set UpSlope. The main current can be
changed using the pedal.
The remote control specifies a percentage value of the set welding current according to the
pedal position.
Manual metal arc welding
The welding current is controlled solely by the welder actuating the pedal.
The further the pedal is depressed, the more current is available.
Pedal not actuated (0%)
... corresponds to the minimum current of
the power source
Pedal fully depressed (100%)
... corresponds to the welding current set
on the power source
0 %
100 %