Fronius Pull, Operating Instructions Manual

Page: 164 / 196

When repeatedly connecting and disconnecting the coolant hoses on the torch
hosepack, grease the O-rings regularly.
Unless a special grease is specified for the O-rings, use the O-ring grease from
Fronius with item number 40,0009,0044.
Whenever the
welding torch or
torch hosepack
is changed Whenever the welding torch or torch hosepack is changed, ensure that the coup-
ling point is clean and dry. Remove any coolant that has escaped from the coup-
ling point.
Changing the
torch hosepack,
changing the in-
terconnecting
hosepack If a robot wirefeeder or a media splitter is mounted in the third robot axis, take
the following into account when changing the torch hosepack or interconnecting
hosepack:
CAUTION!
Risk of damage to the robot wirefeeder or media splitter from escaping coolant.
▶
After disconnecting the coolant hoses on the torch hosepack, close the
coolant connections with the cover provided immediately.
▶
Position the robot in such a way that escaping coolant cannot flow back into
the robot wirefeeder or the media splitter.
2
1
1
Every 6 months
CAUTION!
Danger from compressed air at close range.
Electronic components may be damaged.
▶
Do not bring the air nozzle too close to electronic components.
- Open covers, remove device side panels and clean inside of device with dry
reduced compressed air. After cleaning, restore device to its original state.
164