Fronius Pull, Operating Instructions Manual

Page: 53 / 196

WF Robacta Drive
General The WF 25i Robacta Drive and WF 60i
Robacta Drive CMT are designed for
gas or water-cooled systems. The built-
in motor ensures precise wirefeeding
(pull system). The torch body is fitted
to the Robacta Drive.
Warning notices
on the device The device is fitted with safety symbols and a rating plate. The safety symbols
and rating plate must not be removed or painted over. The safety symbols warn
against operating the equipment incorrectly, as this may result in serious injury
and damage.
WF 25i Robacta Drive rating plate
WF 60i Robacta Drive CMT rating plate
Welding is dangerous. The following basic requirements must be met to ensure
the equipment is used properly:
- Anyone performing automated welding must be sufficiently qualified
- Suitable protective equipment must be used
- All persons not involved must be kept at a safe distance from the wirefeeder
and the welding process
Do not use the functions described here until you have fully read and understood
the following documents:
- These Operating Instructions
- All the Operating Instructions for the system components, especially the
safety rules
53
EN