11
EN-US
Before installation
Safety
Installation speci-
fications
The Fronius Personal Display DL should only be used indoors due to its NEMA 1 degree
of protection.
The device should be protected against direct exposure to moisture.
The antenna can be set up and operated outdoors without limitation.
Inserting a Fro-
nius Display Card
or Fronius Com
Card into the in-
verter
Insert and secure a Fronius Display Card or Fronius Com Card as per the inverter's
operating instructions.
Follow all safety information.
WARNING!
Operating the device incorrectly can cause serious injury and dam-
age. Do not use the functions described until you have thoroughly read and un-
derstood the following documents:
-
these operating instructions
-
all operating instructions for system components, especially the safety rules
WARNING!
An electric shock can be fatal. Danger from grid voltage and DC volt-
age from solar modules.
-
The inverter connection area should only be opened by a licensed electrician
after being disconnected from the grid power.
-
Plug-in cards should only be inserted after the inverter has been disconnect-
ed from the AC and DC sides.
-
Please note the safety information in your inverter's operating instructions.
WARNING!
Risk of injury and damage by overvoltage!
The Fronius Personal Display Card is not suitable for a grid voltage of 277 V AC.
Only operate the Fronius Personal Display Card with the grid voltage specified by
the manufacturer.
NOTE!
Follow general ESD precautions when handling option cards.
NOTE!
When inserting the Fronius Display Card into the Fronius IG, the plug-in
card
-
should only be inserted into slots labeled 'Option 1' or 'Option 2'
-
should not be inserted under any circumstances into the slot on the far left
labeled 'ENS'
1
