Fronius Energy Package, Operating Instructions Manual, Page: 74 / 148

General information for the network administrat-
or
Requirements NOTE! Knowledge of networking systems is required in order to configure Froni-
us system monitoring for the network.
If you are integrating Fronius system monitoring into an existing network, you
must adapt the address settings in line with the network.
e.g.: Network address space = 192.168.1.x, subnet mask = 255.255.255.0
- An IP address of between 192.168.1.1 and 192.168.1.254 must be assigned
to Fronius system monitoring.
- The selected IP address must not be in use on the network already.
- The subnet mask must match that of the existing network (e.g.
255.255.255.0).
If you want Fronius system monitoring to send service messages or to transmit
data to Fronius Solar.web, you must enter a gateway address and a DNS server
address. Fronius system monitoring uses the gateway address for the purpose of
establishing an Internet connection. An example of a suitable gateway address
would be the IP address of the DSL router.
IMPORTANT!
- Fronius system monitoring must never be assigned the same IP address as
the PC/laptop itself!
- Fronius system monitoring is not capable of connecting to the Internet on its
own. In the case of a DSL connection, a router has to establish the Internet
connection.
General firewall
settings DSL routers usually allow data to be sent over the internet and so do not nor-
mally have to be configured for this purpose.
Server addresses for data transfer
If a firewall is used for outgoing connections, the following protocols, server ad-
dresses and ports must be allowed for successful data transfer:
- Tcp fronius-se-iot.azure-devices.net:8883
- Tcp fronius-se-iot.azure-devices.net:443
- Tcp fronius-se-iot-telemetry.azure-devices.net:8883
- Tcp fronius-se-iot-telemetry.azure-devices.net:443
- Udp sera-gen24.fronius.com:1194 (213.33.117.120:1194)
- Tcp froniusseiot.blob.core.windows.net:443
- Tcp provisioning.solarweb.com:443
- Tcp cure-se.fronius.com:443
- NTP 0.time.fronius.com
If existing firewall rules block the connection to the Fronius system monitoring
function, the following firewall rules must be added:
49049/UDP
output
80/TCP *)
Input
Sending of service messages x -
74