Fronius Energy Package, Operating Instructions Manual, Page: 116 / 148

60 %
30 %
0 %
0,95
0,90
0,85
(1)
(2)
(4)
+
-
IO 2
IO 3
I 4
I 7
I 8
I 9
IO 0
(3)
The ripple control signal receiver and the Fronius system monitoring connector
are connected to one another by means of a four-pin cable in accordance with
the connection diagram.
If the distance between the Fronius system monitoring datalogger and the ripple
control signal receiver exceeds 10 m, a shielded cable is recommended.
DNO Editor settings:
Ap-
prove
d
Input pattern
Effective
power
Power factor cos
φ ;
DNO output
Excluded in-
verter
*
(1)
(2)
... not usable ... not considered etc. contact open etc. contact closed
"PSC editor -
AUS - Demand
Response Modes
(DRM)" A value for the apparent power consumption and apparent power output can be
entered here for the Australia country setup.
DNO Editor –
Dynamic power
reduction Electricity retailers or grid operators may stipulate feed-in limitations for an in-
verter (e.g. max. 70% of kWp or max. 5 kW).
Dynamic power reduction takes account of self-consumption by the household
before the power of an inverter is reduced:
116