Fronius DeltaSpot, Operating Instructions/Spare Parts List

Page: 14 / 84

12
Safety measures
in normal opera-
tion
Maintenance and
repair
Use internal directives and checks to ensure that the workplace environment
is always clean and clearly laid out.
Only set up and operate the device in accordance with the degree of protec-
tion shown on the rating plate.
When setting up the device, ensure there is an all-round clearance of 0.5 m
(1.6 ft.) so that cooling air can flow in and out unhindered.
When transporting the device, observe the relevant national and local guide-
lines and accident prevention regulations. This applies especially to guidelines
regarding the risks arising during transportation.
Before transporting the device, allow coolant to drain completely and detach
components.
After transporting the device, the device must be visually inspected for dam-
age before commissioning. Any damage must be repaired by trained service
technicians before commissioning the device.
Only operate the device when all protection devices are fully functional. If the
protection devices are not fully functional, there is a risk of
-
injury or death to the operator or a third party,
- damage to the device and other material assets belonging to the operat-
ing company,
- inefficient operation of the device.
Any safety devices that are not functioning properly must be repaired before
switching on the device.
Never bypass or disable protection devices.
Before switching on the device, ensure that no one is likely to be endangered.
- Check the device at least once a week for obvious damage and proper
functioning of safety devices.
- Use only appropriate coolant. Note the cooling unit manufacturer's in-
structions.
- If damage results from using a different coolant the manufacturer accepts
no liability. In addition, all warranty claims are forfeited.
- Check the coolant level before you start to weld while the system is still
cool.
It is impossible to guarantee that bought-in parts are designed and manufac-
tured to meet the demands made on them, or that they satisfy safety require-
ments. Use only original replacement and wearing parts (also applies to
standard parts).
Do not carry out any modifications, alterations, etc. to the device without the
manufacturer's consent.
Components that are not in perfect condition must be changed immediately.
When ordering, please give the exact designation and part number as shown
in the spare parts list, as well as the serial number of your device.