Fronius Datamanager 2.0, Operating Instructions Manual

Page: 79 / 88

Settings – Counter
General IMPORTANT! Settings in the “Counter” menu item may only be entered by staff trained
to do so!
The service password must be entered for the “Counter” menu item.
Three-phase or one-phase Fronius Smart Meters may be used. In both cases, selection
is made via the “Fronius Smart Meter” item. The Fronius Datamanager automatically de-
tects the counter type.
A primary meter or, optionally, multiple secondary meters can be chosen. The primary
meter must be configured before a secondary meter can be chosen.
Fronius Smart
Meter When the Fronius Smart Meter is chosen as a counter the field “Settings” must be used
to set the counter position.
“ Meter position ” at “ Feed-in point ” (1a)
The power of feeding in and energy are measured. The consumption is determined using
these values and the system data.
“ Meter position ” in “ Consumption branch ” (1b)
The consumed power and energy are measured directly. The power of feeding in and en-
ergy are determined using these values and the system data.
(1a)
(1b)
Secondary meter
If a Fronius Smart Meter was chosen as a secondary meter, a window will open to enter
the
“Description” (freely selectable) as well as a “ Modbus address ” field. A value is
suggested automatically in the “Modbus address” field (next free address in the address
range). The modbus address must not be assigned twice. Click on “
Scan ” after entering.
79
EN-US