Fronius ActiveCharger 1000, Operating Instructions Manual

Page: 61 / 72

61
EN
Before commissioning
Mains connection The rating plate, which is located on the housing, contains information about the permitted
mains voltage. The device is designed for this mains voltage only. For details on the re -
quired fuse protection for the mains lead, see the Technical data section on page 68 . If
there is no mains cable or mains plug on your version of the appliance, fit one that con -
forms to national standards.
CAUTION!
Danger due to insufficiently dimensioned electrical installations.
This can result in serious damage to property.
► The mains lead and its fuse must be dimensioned to suit the local power supply.
► Read the technical data on the rating plate.
Generator-pow -
ered operation
The charger is completely generator-compatible, provided the maximum apparent power
delivered by the generator is at least 2 kVA.
This also applies if the generator in question is an inverter.
NOTE!
The voltage delivered by the generator must never exceed the upper or lower limits
of the mains voltage tolerance range.
Details on the mains voltage tolerance can be found in the Technical data section on
page 68 .
Setup regulations
WARNING!
Toppling or falling devices can cause life-threatening injuries.
Place devices on a solid, level surface so that they remain stable.
The device is tested to IP 43S protection, meaning:
- protection against penetration by solid foreign bodies with diameters > 1.0 mm (0.04
in.)
- protection against direct sprays of water at any angle up to 60° from the vertical, if the
fan does not run.
Dust
Ensure that metallic dust is not sucked into the system by the fan, when carrying out grind -
ing for example.
Outdoor operation
The device can be set up and operated outdoors in accordance with IP43S degree of pro -
tection. Avoid direct wetting (e.g. from rain).