Fromm FS380, Use And Maintenance Manual, Page: 42 / 100

36
Rev.2 01/03/2021
Use and Maintenance Manual | TURNTABLE - MAST
36
3.3.1 OPTIONAL EQUIPMENT
3.3.1.1 AUTOMATIC CUT
1
The automatic cycle can be used when the machine is equipped with
the cutting unit, for cutting the film at the end of the cycle.
The cutting unit, with the blade (1) , includes the film coming out of the
carriage and can also be installed after purchase of the machine.
During the last rotation, the roll holder carriage blocks the rollers and
after the time set with F27 , the machine stops, tightening the film,
which is cut by the blade the number of times set with F26 .
After cutting, the machine starts again, the carriage freely dispenses
the film for a time set with F28 , after which is blocks the rollers again,
causing the film to break.
WARNING
The optional AUTOMATIC CUTTER and STRIP CUTTER cannot be
installed on the machine at the same time; one installation
excludes the other.
Picture 21