Fromm FS380, Use And Maintenance Manual, Page: 14 / 100

8
Rev.2 01/03/2021
Use and Maintenance Manual | TURNTABLE - MAST
8
2.2 SAFETY SIGNS
Before starting work, the operator must be perfectly familiar with the
position and functioning of all the controls and machine features. Daily
check all the safety devices on the machine.
• Before starting the working cycle, the operator must ensure that
there are no EXPOSED PERSONS in the HAZARDOUS ZONES.
• The employer must provide and instigate the use of personal
protective equipment conforming to the prescriptions of
Directive 89/391/EEC(and subsequent revisions). While using
and carrying out maintenance on the machine the use of
personal protective equipment (PPE) such as safety footwear
and overalls, approved for accident prevention, is obligatory.
• The areas where the operator stands must always be kept clear
and free of oily residues.
• It is forbidden to approach the moving parts of the machine,
such as the carriage and rotating parts, when the machine is in
operation.
• It is strictly prohibited to operate the machine in automatic
mode with the fixed and/or mobile safety guards removed.
• It is strictly prohibited to disable the safety devices installed on
the machine.
• Any adjustment operations that need to be carried out with
some of the safety devices disabled must be performed by one
person only, and unauthorised persons may not access the
machine during this time.
• The room in which the machine is housed must not have any
shadow areas, annoying bright lights or hazardous stroboscopic
effects caused by the lighting supplied.
• The machine can operate in clear air conditions at ambient
temperatures of +5°C to +40°C.
• The machine must be used exclusively by qualified personnel.
DANGER
THE MACHINE MUST ONLY BE USED BY ONE OPERATOR AT A TIME,
USE OF THE MACHINE BY 2 OR MORE OPERATORS AT THE SAME
TIME IS FORBIDDEN.
DANGER
During all maintenance, repair or adjustment operations, IT IS
OBLIGATORY TO TURN THE MAIN SWITCH TO (0-OFF).
If you need to conduct work inside the electrical panel, always turn
off the voltage upstream the machine using the mains switch, as
the terminal board is powered on even though the panel is open
and the machine switch is set to “OFF”.
It is advisable to post a warning sign on the control panel onboard
the machine or on the main power switch (whatever applicable);
this sign should read as follows:
WARNING! DO NOT TOUCH - MAINTENANCE STAFF AT WORK.
DANGER
DO NOT REMOVE THE FIXED GUARDS WHEN THE MACHINE
IS RUNNING. ALWAYS REFIT THE FIXED GUARDS AFTER ANY
MAINTENANCE OPERATION.
DANGER
IT IS PROHIBITED TO ATTEMPT TO COUNTERACT, SLOW DOWN OR
STOP THE MACHINE DURING THE AUTOMATIC WRAPPING CYCLE.
USE ONLY THE STOP BUTTON OR THE EMERGENCY BUTTON TO
BRING IT TO A HALT.
As soon as possible after an operation that required disabling of some
safety devices, the machine must be restored to a safe state by re-
enabling all the safety devices.
Do not for any reason modify parts of the machine (e.g. attachments,
holes, finishes, etc.) in order to adapt it to other devices. We therefore
advise you to request any modifications directly from the Manufacturer.
»
See Picture 1 - pag. 9
The safety signs described in this manual, are located on the machine
structure at suitable points and warn of the likelihood of danger due
to residual risks.
The adhesive stickers, distinguished by yellow and black bands, warn of
areas of risk for operators and so maximum care must be taken where
these signs are located.
The adhesive stickers applied to the machine must always be kept
clean and legible.