NOTICE!
If both crushing plates were rotated or replaced,
re-adjust the gap width as described in the fol-
lowing chapter.
18.
Close the lid (7).
19.
Push in the source material container (8).
6.3.3 Checking the gap width
DANGER!
Mains voltage!
– Before beginning with maintenance and assembly
work, disconnect the mains plug and protect the
device against being unintentionally switched back
on!
– Indicate maintenance and assembly work with
warning signs.
NOTICE!
During operation of the jaw crusher, the crushing plates
must not touch when the smallest gap width is set.
Tools
c
Hex wrench - size 6
d Feeler gauge strip
e Open-ended wrench - size 19
n Cross-head screwdriver
After mounting the crushing plates (17, 21), you need to
check the gap width between the crushing plates.
Using the device
- 33 -
