14.
Attach the cable conduit of the funnel (B) to the back cover of the
jaw crusher. To do so, remove the screw at the top right using a
cross-head screwdriver (N).
15.
Push the cable clamp (E) onto the funnel cable.
16.
Then, screw on the cable clamp (E) at this position (top right) using
the cylinder head screw M6x12 (F).
7.3 Crushing and grinding in combination with the Disk Mill PULVERISETTE 13 classic
line
For finer comminution of coarse material before its subsequent use,
which would not be possible with the jaw crusher alone, the Laboratory -
jaw crusher is used in combination with the Disk Mill PULVERISETTE 13
classic line.
The comminution is done in this combination in a single pass with 95
mm (or 65 mm) feed size up to an average particle feed size (d
50
) of 0.1
mm.
The PULVERISETTE 1 classic line is placed on a mounting rack (order no.
43.5100.00) above the disk mill. The material pre-crushed in the PUL-
VERISETTE 1 classic line passes directly into the funnel of the disk mill via
a special chute.
Accessories
- 41 -