Before adding wetting agent through the opening (O),
please stop the sieve shaker with the Stop key.
6.3.4 Extracting the passing particles
In order to extract the rinsed out fine particles, the outlet hose can be
connected e.g. to a suction funnel with filter paper.
Clear liquid flowing from the sieve pan indicates the end
of the sieving process.
6.3.5 Tips for wet sieving of difficult sieving stock
n
For wet sieving of difficult sieving stock, reduce the feed quantity
and choose sieves with closely staggered mesh widths.
n
Switch on Interval mode; sieving time: 3...5s (only possible with ANA-
LYSETTE 3 PRO)
n
After the top sieve has sieved completely (is free of fine particles)
remove the top sieve after taking off the clamping lid and clamp the
clamping lid on the next sieve. Now the spray jets work directly on
the following fraction. Proceeding in this way makes it possible to
sieve each individual sieve of the sieve set directly using spray jets.
The spray jets are directed so that the sieving stock is rinsed from the
edge of the sieve towards the middle. In the process, the clamping
lid (plexiglas lid) is also sprayed and kept free of material.
n
When wet sieving difficult sieving stock, insert an intermediate sieve
ring (order no.: 31.0240.00) over a lower sieve to avoid a backup on
it. After this ring is connected to the hose system, additional liquid is
sprayed in through three nozzles and thus counteracts a possible
backup. These nozzles are arranged so that the lower as well as the
upper sieve surfaces are sprayed. This arrangement also circulates
the sieving stock. If necessary, a further intermediate sieve ring can
also be mounted above a sieve that is prone to backup.
Using the device
- 28 -
